Sidestand Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
SIDESTAND
REMOVAL/INSTALLATION
Remove the sidestand switch (page 22-27) (not
necessary to disconnect the connector).
Support the motorcycle securely using a hoist or
equivalent.
Remove the sidestand return springs [1].
Remove the sidestand pivot nut [2] and bolt [3], then
remove the sidestand [4] and collar [5].
Apply molybdenum disulfide grease to the sidestand
pivot bolt sliding surface and collar outer surface.
Install the sidestand and collar.
Install and tighten the pivot bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
After tightening the pivot bolt, return the pivot bolt 45°.
Install and tighten the sidestand pivot nut to the
specified torque while holding the sidestand pivot bolt.
TORQUE: 29 N·m (3.0 kgf·m, 21 lbf·ft)
Install the sidestand and return springs in the direction
as shown.
Install the sidestand switch (page 22-27).
FRAME/BODY PANELS/EXHAUST SYSTEM
[2]
[5]
[4]
[3]
Up
Rear
[1]
2-19