Nuts, Bolts, Fasteners Maintenance - Honda CRF1000 Shop Manual

dummyhead dummyhead
REBOUND DAMPING ADJUSTER
• Always start on fully hard when adjusting the
damping.
• Do not turn the adjuster screws more than the given
positions or the adjusters may be damaged.
The rebound damping can be adjusted by turning the
adjuster [1].
Turn the rebound adjuster clockwise until it stops
(maximum
counterclockwise.
REBOUND ADJUSTER STANDARD POSITION
(from maximum position):
11 clicks
COMPRESSION DAMPING ADJUSTER
• Always start on fully hard when adjusting the
damping.
• Do not turn the adjuster screws more than the given
positions or the adjusters may be damaged.
The rebound damping can be adjusted by turning the
adjuster [1].
Turn the compression adjuster clockwise until it stops
(maximum
counterclockwise.
REBOUND ADJUSTER STANDARD POSITION
(from maximum position):
14 clicks
NUTS, BOLTS, FASTENERS
Check that all chassis nuts and bolts are tightened to
their correct torque values (page 1-12).
Check that all safety clips, hose clamps and cable stays
are in place and properly secured.
position), then turn the
position), then turn the
adjuster
adjuster
MAINTENANCE
[1]
[1]
3-25