Table of Contents
Advertisement
dummyhead
dummyhead
CUSHION LINKAGE
REMOVAL
Support the motorcycle using a safety stand or hoist,
raise the rear wheel off the ground.
Remove the sidestand (page 2-19).
Remove the following:
– Cushion connecting rod mounting nut [1] and bolt [2]
– Rear shock absorber lower mounting nut [3] and bolt
[4]
– Upper cushion arm nut [5] and bolt [6]
– Cushion arm/connecting rod [7]
DISASSEMBLY/INSPECTION
Disassemble the cushion arm [1] and connecting rod [2]
by removing the lower cushion arm nut [3] and bolt [4].
Remove the collars [1] and dust seals [2] from the
cushion arm [3].
Check the collars and dust seals for wear or damage
and replace if necessary.
Check the cushion arm for cracks or damage and
replace if necessary.
Check the needle bearings for damage or loose fit.
Remove the collar [1] from the cushion connecting rod
[2].
Check the collar for wear or damage and replace if
necessary.
Check the cushion connecting rod for cracks or damage
and replace if necessary.
Check the needle bearings for damage or loose fit.
REAR WHEEL/SUSPENSION
[5]/[6]
[7]
[3]/[4]
[1]
[4]
[2]
[1]
[1]/[2]
[2]
[3]
[3]
[2]
[2]
[1]
18-9
Advertisement
Table of Contents
Troubleshooting
