Front Wheel Installation; Fork Removal - Honda CRF1000 Shop Manual

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION
Install the side collars [1] to the front wheel.
Apply a thin coat of grease to the front axle sliding
surface.
Install the front wheel between the forks.
Install the front axle [2] from right side.
Align the surfaces of
the axle and right
Tighten the right front axle holder pinch bolts [4] to the
fork [3] as shown.
specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Install and tighten the axle nut [5] to the specified
torque.
TORQUE: 60 N·m (6.1 kgf·m, 44 lbf·ft)
Loosen the right front axle holder pinch bolts.
Tighten the left front axle holder pinch bolts [6] to the
specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Install the front brake calipers (page 19-18).
With the front brake applied, pump the forks up and
down several times to seat the axle and check brake
operation.
Tighten the right front axle holder pinch bolts to the
specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
ED model: Install the axle cap [7].
Check the clearance gap between the front wheel
speed sensor bracket and pulser ring (page 20-21).
FORK
REMOVAL
Remove the following:
– Front fender (page 2-9)
– Front wheel (page 17-10)
– Front speed sensor (CRF1000A/D) (page 20-20)
Loosen the top bridge pinch bolts [1].
If the fork will be disassembled, loosen the fork bolts [2]
Be careful not to
at this point, but do not remove yet.
damage the fork
bolt when loosening
Loosen the fork bottom bridge pinch bolts [3] by holding
it.
the forks then remove it.
17-14
Right side: [1] Left side:
[1]
[2] [4] [6]
[3]
[2] [1]
[5]
[7]
[2]
[3]