Battery Box Removal/Installation; Voltage Inspection - Honda CRF1000 Shop Manual

dummyhead dummyhead
BATTERY/CHARGING SYSTEM
BATTERY BOX REMOVAL/
INSTALLATION
Remove the following:
– ECM/PCM (page 4-39)
– Starter relay switch (page 6-7)
– Insulators (page 10-19)
Release the main wire harness [1] from the clamp [2].
Release the main wire harness clip [3] from the frame.
Release the main wire harness clip [4] from the battery
box.
CRF1000A/D: Disconnect the starter battery cable 2P
connector [5].
CRF1000A/D: Release the brake pipes from the clamp
[6].
CRF1000A/D: Remove the bolt [7] and release the
brake pipe/hose joint from the frame.
Remove the bolt/washers [1].
Release the following from the battery box:
– CRF1000/A: Siphon hose [2]
– CRF1000D: Parking brake cable [2]
Remove the battery box [3].
Installation is in the reverse order of removal.
• Align the left/right battery box grooves with the
engine hanger collars.
• Route the wire harnesses, hoses, pipes, and cables
properly (page 1-26).

VOLTAGE INSPECTION

Open the battery box lid (page 21-5).
Measure the battery voltage using a commercially
available digital multimeter.
VOLTAGE (20°C/68°F):
Fully charged:
Needs charging: Below 12.3 V
21-6
13.0 – 13.2 V
CRF1000D shown: [4]
[3] [1] [2]
CRF1000D shown:
[1]
Right side shown:
Align
[6] [5]
[7]
[1] [2]
[3]