Fuel Injector Assembly/Installation; Secondary Air Supply System Inspection - Honda CRF1000 Shop Manual

dummyhead dummyhead
FUEL SYSTEM
ASSEMBLY/INSTALLATION
Apply engine oil to new O-rings and seal rings.
Assemble the following:
– Seal rings [1]
– Fuel injectors [2]
– O-rings [3]
– Fuel injector joints [4]
– O-rings [5]
– Fuel rail [6]
• Align the injector connectors with the fuel joint tabs
to position them upright.
Install the fuel injector assembly [1].
• When installing the fuel injector, be careful not to
damage the seal ring.
Install and tighten the bolts [2] to the specified torque.
TORQUE: 5.1 N·m (0.5 kgf·m, 3.8 lbf·ft)
Connect the fuel injector 2P (Black) [3] and 2P (Blue)
[4] connectors.
Install the ECM/PCM (page 4-39).
SECONDARY AIR SUPPLY SYSTEM
SYSTEM INSPECTION
Start the engine and warm it up to normal operating
temperature.
Stop the engine.
Remove the air cleaner housing (page 7-11).
Check that the secondary air intake port [1] of the
element holder is clean and free of carbon deposits.
Check the PAIR reed valve if the port is carbon fouled
(page 7-21).
7-18
[6]
Align
[1]
[3]
[5]
[4]
[3]
[2]
[1]
[2]
[4]
[1]