Clutch Lifter Lever - Honda CRF1000 Shop Manual

dummyhead dummyhead
Remove the dowel pins [1] and gasket [2].
Remove the O-ring [1].

CLUTCH LIFTER LEVER

Remove the clutch lifter lever [1] and return spring [2].
Remove the oil seal [3].
Check the needle bearings [4] and replace if necessary.
Installation is in the reverse order of removal.
• Coat new bearings with engine oil and install them to
the specified depth as shown.
• Replace the oil seal with a new one and install it to
the specified depth as shown.
• Apply grease to a new oil seal lips.
• Align the return spring end with the clutch lifter lever
groove.
• Align the return spring hook with the right crankcase
cover groove.
CLUTCH/GEARSHIFT LINKAGE (CRF1000/A)
[1]
Align
[3]
[1]
[1]
Align
6.5 – 7.5 mm
(0.26 – 0.30 in)
0.3 – 0.8 mm
(0.01 – 0.03 in)
[4]
69.4 – 70.4 mm
(2.73 – 2.77 in)
12-5
[1]
[2]
[2]