dummyhead
dummyhead
LIGHTS/METERS/SWITCHES
TURN SIGNAL LIGHT DIODE
REMOVAL/INSTALLATION
Remove the pillion seat (page 2-11).
Remove the turn signal light diode [1].
Installation is in the reverse order of removal.
INSPECTION
Check for continuity between the turn signal light diode
[1] terminals.
When there is continuity, a small resistance value will
register.
If there is continuity in one direction, the turn signal light
diode is normal.
TURN SIGNAL LIGHT/RELAY
(CRF1000A/D)
TURN SIGNAL LIGHT REMOVAL/
INSTALLATION
FRONT
Remove the inner panel cover (page 2-8).
Disconnect the front turn signal light 2P connector [1].
– Right side: light blue
– Left side: orange
Remove the following:
– Nut [2]
– Collar [3]
– Grommet [4]
– Front turn signal light [5]
– Front turn signal light cover [6]
Installation is in the reverse order of removal.
22-8
(–)
(+)
Right side shown:
[6]
[5]
[1]
[1]
[1]
[2]
[3]
[4]