Table of Contents
Advertisement
dummyhead
dummyhead
SIDESTAND SWITCH
REMOVAL/INSTALLATION
Remove the left rear cover (page 2-10).
CRF1000D: Remove the shift control motor cover (page
13-71).
Remove the connector cover (page 5-8).
Disconnect the sidestand switch 2P (Black) connector
[1].
Remove the bolt [1] and sidestand switch [2].
Installation is in the reverse order of removal.
• Replace the bolt with a new one.
• Align the sidestand switch tab [3] with the sidestand
hole [4].
• Align the sidestand switch groove [5] with the return
spring holding pin [6].
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
INSPECTION
Disconnect the sidestand switch 2P (Black) connector
(page 22-27).
Check for continuity at the switch side 2P (Black)
connector [1].
CONNECTION: Green/white – Green
There should be continuity with the sidestand retracted
and no continuity with the sidestand lowered.
LIGHTS/METERS/SWITCHES
CRF1000D shown:
[1]
[2]
G/W
[1]
[6]
[4]
[3]
[5]
[1]
G
22-27
Advertisement
Table of Contents
Troubleshooting
