Vs Sensor Removal/Installation; O2 Sensor Removal/Installation; Bank Angle Sensor Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
PGM-FI SYSTEM
VS SENSOR
REMOVAL/INSTALLATION
Remove the battery box (page 21-6).
Disconnect the VS sensor 3P (Black) connector [1].
Remove the following:
– Bolt [2]
– VS sensor [3]
– O-ring [4]
Installation is in the reverse order of removal.
• The VS sensor and outer mainshaft sensor are the
same parts.
• Replace the O-ring with a new one and coat it with
engine oil.
• Install the O-ring into the groove in the VS sensor.
O SENSOR
2
REMOVAL/INSTALLATION
Remove the exhaust pipe (page 2-17).
Remove the O
TOOL:
Sensor socket wrench [2]
• Handle the O
• Do not get grease, oil, or other materials in the O
sensor air hole.
• Be careful not to damage the sensor wire.
• Do not use an impact wrench while removing or
installing the O
• Do not service the O
Installation is in the reverse order of removal.
TORQUE: 24.5 N·m (2.5 kgf·m, 18 lbf·ft)
BANK ANGLE SENSOR
REMOVAL/INSTALLATION
Remove the headlight (page 22-4).
Remove the nuts [1] and bank angle sensor [2].
4-42
sensor [1] using the special tool.
2
FRXM17 (Snap on)
or equivalent
sensor with care.
2
sensor.
2
sensor while it is hot.
2
CRF1000D shown:
[2]
[4]
[3]
[1]
2
[2]
[1]
[2]
[1]