Horizon Fitness CRF-362 User Manual page 84

If an Error Code Is Displayed
Error Code
Transport Section Cover
Open (Cover Switch S12)
102
Front Cover Open
(Cover Switch S13)
103
Feed Table Overlimit Error
200
Feed Table Movement Error
201
Misfeed
210
Double Feed
211
Sheet Feed Section Jam
(Sensor B13 is on before
operation.)
212
The Transport Interval Is Too
Narrow
213
Register Transport Section
Jam
(The sheet did not arrive at
300
sensor B30.)
Register Transport Section
Jam
(Sensor B14 is on before
operation.)
301
Too Many Sheets at Regis-
tration Transport Section
310
84
Description
Close the cover.
Close the cover.
The feed section upper guide was lifted up while the feed table was rising.
Lower the feed table and then check if there is no foreign object be-
tween the feed table and the feed section upper guide.
The feed table could not move up and down.
Check if there is no object preventing the feed table from moving up
and down.
A sheet was not fed. If the same error occurs repeatedly, see page
89 and follow the instructions.
A double feeding occurred. If the same error occurs repeatedly, see
page 89 and follow the instructions.
A sheet was detected when
See page 70 and set the transport interval larger.
A jam has occurred in the register transport section. Remove the
sheet. If the same error occurs repeatedly, see page 90 and solve
the problem.
A sheet was detected when
Remove the sheet.
If this error code is displayed even though no sheets are jammed, the
sensor may be dirty. Check that the sensor works properly using the
Information - Monitor screen. (See page 39 .)
Before a sheet was detected by the B30 creasing section sheet leading
edge sensor, the next sheet was detected by the B13 double feed sen-
sor.
Remove the sheet.
If the same error occurs repeatedly, set the transport interval larger.
(See page 70 .)
Causes and Solutions
Feed Section Upper Guide
13130
40201A1
is pressed. Remove the sheet.
is pressed.
CRF-362