Table of Contents
Advertisement
Screen Descriptions
1-3-21
Information - Administrator - Administrator Settings Screen
1
2
3
4
5
6
7
8
1
Power Saving Mode
When you want the machine to go into the power
saving mode automatically, select on.
2
Time To Power Saving (minute)
This sets the delay before the machine goes into
the power saving mode.
3
Counter Setting
This sets the counting method for the preset func-
tion and the offset function.
Count down (From set number to zero)
Count up (From zero to set number)
4
Filter Cleaning Alarm for Cooling Fan
Press this value box and the Numeric Keypad screen
appears. Enter the time to display the alarm for clean-
ing the air filter.
5
Hinge Crease Distance
Set the distance between the spine corner of the cover
and the crease that is the nearest to the spine corner.
The distance in
this position.
The distance in
The distance in
this position.
this position.
44
6
7
The distance in
this position.
8
13130
10316A1
Positive/Negative Reverse Mode
Default Setting
You can select the default setting of the positive/
negative reverse mode that is set on the Run - Fine
Adjustment - Creasing and Fold screen or the Run -
Fine Adjustment - Creasing for Cover screen.
OFF: Normal setting is set as default. A negative
crease is creased on the mountain fold posi-
tion. This is ideal for thick sheet.
ON: Reversed setting is set as default. A positive
crease is creased on the mountain fold posi-
tion. This is ideal for thin sheet.
Spine Corner Position Correction
If the spine corners move because the sheet is bent for the
creasing lines, enter a correction value. The spine corner
position is shifted to the right by the entered value.
Adjustable Range: 0 to 0.9 mm / 0 to 0.035"
Factory Default Setting: 0.3 mm / 0.010"
Sheet Feeding
Direction
These distances differ in right and left.
The two spine corners are shifted to parallel if you enter the correction value.
Go to the Information - Main Screen
CRF-362
Advertisement
Table of Contents
