Intermediate Shaft; Removal - Honda CR-V 1997 Service Manual

Front Driveshafts
Installation (cont'd)
6, Install the damper fork over the driveshaft and onto
the lower arm. Install the damper in the damper
fork so the aligning tab is aligned with the slot in
the damper fork.
FLANGE
BOLT
10 x 1.25 mm
43 N·m IU kgf·m. 32 IbHtl
12 x 1.25 mm
64 N·m 16.5 kgf·m. 47 IbHtl
Replace.
ALIGNING TAB
DAMPERFDRK
7. Loosely install the flange bolts and the new self-
locking nut.
8. Apply oil to the seating surface of the new spindle nut.
I \
FRONT WHEEL ( \ . ' 1 WHEel NUT t2
x
1.5 mm
. ---l.-.Y
108 N'm 111.0 kgf·m. 80 IbHt)
, !
IV--
' ~
.~
':?'
-~
_ I
-,
SPINDLE NUT
--+ ......
2.x1.5mm
245N·m
125.0 kgf·m. 181 IbHtl
NOTE: After tightening. use a drift to
/'
,
!
I
stake the spindle nut shoulder against the driveshaft.
9. Install a new spindle nut, then tighten the nut.
10. Clean the mating surfaces of the brake disc and the
wheel, then install the front wheel with the wheel
nuts.
11 . Tighten the flange bolts and the new self-locking
nut with th e vehicle 's weight on the damper.
12. Refill the transmission with recommended fluid (see
section 13 or 14).
13. Check the front wheel alignment, and adjust if nec-
essary (see section 18).
16-18
Intermediate Shaft
Removal
1. Drain the transmission oil or fluid (see section 13 or
141.
2. Remove the left driveshaft Isee page 16-31.
3. Remove the three dowel bolts.
DOWEL BOLTS
10x 1.25mm
4. Remove the intermediate shaft from the differential.
Hold the intermediate shaft horizontal until it is clear of
the differential to prevent damage to the differential oil
seal.
IN1<RMEDIATE SHAFT