Park Pin Switch - Over-Drive (010) Switch Replacement - Honda CR-V 1997 Service Manual

Park Pin Switch - Over-Drive (010) Switch Replacement - '99 - 00 Models
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS
section
(24)
before performing repairs or service.
NOTE: If replacement of the park pin switch or the 0 10 switch is required, replace them as a set.
1. Remove the instrument panel lower cover (see section 20).
2. Remove the upper and lower steering column covers (see section 17).
3. Remove the flange nuts securing the steering column, then lower the steering column.
4. Disconnect the shift lock solenoid and the park pin switch - 0 10 switch connectors.
5. Remove the harness clamp bracket.
6. Remove the bolts securing th e shift 1ever assembly, then remove the shift lever assembly,
7. Remove the screws securing the shift lock solenoid, then remove the shift lock solenoid.
8. Cut the
%
switch wires (RED and BLK), then remove the connector from the shift lever control bracket.
g, Remove the control checker from the shift lever control bracket,
10. Remove the park pin switch from the control checker.
11. Remove the shift lever knob from the shift lever, then remove the % switch from the shift lever knob.
PARK PIN SWITCH -
010 SWITCH
CONNECTOR
SCREW
2.5 N·m (0.25 kgf'm .
1.8Ibf.f'1
SHIFT LEVER CONTROL
BRACKET HARNESS CLAMP
PARK PIN
SWITCH
CONTROL
CHECKER
SHIFT LEVER
010 SWITCH
HARNESS ClAMP BRACKET
9.3
Nom
(0.95 kgf·m .
6.9Ibl·h)
SHIFT LEVER KNOB
6 -12 N'm
10.6 - 1.2 kgl·m •• - 8.7 Ibl·hl
12. Route the new % switch wires through the shift lever knob, shift lever, and shift lever control bracket, then instal l
the knob on the shift lever, and install the switch in the knob.
13. Install the new park pin switch on the control checker, then install the control checker on the shift lever control brack-
et.
14. Route the park pin switch harness through the cut out of the shift lever control bracket.
15. Install the
OlD
switch wire terminals in the connector cavities securely. The wire termina ls can be installed in cavity
No.1 or No. 2.
16. Install the connector and the harness clamp on the bracket.
17. Install the shift lock solenoid by aligning the joint of the shift lock solenoid plunger with the tip of the shift lock exten-
sion, then secure the shift lock solenoid with the screws.
18. Install the shift lever assembly in the reverse order of removal.
19. Adjust the clearance between the 0 10 switch wires and the edge of the shift lever control bracket Isee page 14-2701.
20. Check the shift lever operation and shift lock operation.
14-151