Passenger's Door Lock Actuator Test; Driver's Door Lock Switch Test - Honda CR-V 1997 Service Manual

Passenger's Door Lock Actuator Test
1. Remove the passenger's door panel (see section 20).
2. Disconnect the 2P connector from the actuator.
NOTE: The left rear door lock actuator is shown;
the front passenger's and right rear door lock actua-
tors are similar.
2P CONNECTOR
Terminal side of
male terminals
3. Check actuator operation by connecting power and
ground according to the table. To prevent damage
to the actuator, apply battery voltage only momen-
tarily.
Terminal
\
1 2
Position
LOCK
e
$
UNLOCK
(!)
e
4. If the actuator does not work properly, replace
it.
Driver's Door Lock Switch Test
1. Re move the inner handle (see section 20).
2. Disconnect the 3P connector, then remove the two
mounting screws and driver's door lock switch.
3P CONNECTOR
DRIVER'S
DOOR LOCK
SWITCH
g
er\
\ !
!
I;
INNER HANDLE
3. Check for continuity between the terminals in each
switch position according to the table.
1 , \
Terminal
'\
1 2
3
Position
LOCK
OFF
UNLOCK
V
23-129