Front Seat Belt Replacement; Front Seat Belt - Honda CR-V 1997 Service Manual

Front Seat Belt Replacement
SRS
components are
located in this area. Review the SRS
component locations, precautions, and procedures in this
section (24) before performing repairs or service ('98 - 00
modelsl.
CAUTION: Check the front seat bait. for damaga, and
replace them if necessary. Be careful not to damage
them during removal and installation.
Front seat belt:
1, Make sure you have the anti-theft code for the
radio, then write down the frequenci es for the pre-
set buttons.
2. Disconnect the negative battery cable, and wait at
least three minutes before beginning work.
3. Slide the front seat forward fully .
4. Remove (see section 20):
• Center pillar lower trim panel
• Kick panel
• Front side trim
5. '97 model: Remove the upper anchor cover and the
lower anchor cap.
'98 - 00 models: Remove the upper anchor cover
and pull the lower anchor cover back.
UPPER ANCHOR BOLT
7/'6-20 UNF
32 N·m 13.3 kgf·m,
24'bHII
Apply liquid thread
lock.
RETRACTOR
MOUNTING BOLT /
6xl .0mm :/"
9.8 N·m 1'.0 kul·m.
7.21bl-l'l
~
RETRACTOR
RETRACTOR BOLT
7/16-20
UNF
32 Nom 13.3 kgf·m.
241bl-l'I
SHOULDER
ANCHOR
A~JUSTER
FRONT SEAT
BELT
SEAT BELT
TENSIONER
CONNECTOR
('98 - 00 modetsJ
REAR SIDE
TRIM
~'-c--I-!-_ LOWER
ANCHOR
COVER
('98 -
00
models)
" ' L O W E R
ANCHOR
CAP
('97 model)
LOWER ANCHOR BOLT
7/16-20
UNF
32 N·m 13.3 kgl·m. 241bl-l'I
6. Disconnect the seat belt tensioner connector.
To avoid accidental deployment and
always
disconnect
the .. at belt ten-
sioner connector before removing the retractor j'98
- 00 models, see page 24-231.
7. Remove the upper and lower anchor bolts, the
retractor bolt, the retractor mounting bolt, an d
remove the front seat belt and retractor .
8. Remove the center pillar upper trim (see section 20).
9. Remove the shoulder anchor adjuster.
8x 1.25mm
23 N·m 12.3 kgf·m,
17 IbH'1
SHOULDER
ANCHOR
ADJUSTER
10. Installation is the reverse of the removal procedure.
NOTE:
• Check that the retractor locking mechanism func-
tions as described on page 24-9.
• Assemble the washers, collar and bushing on the
upper and lower anchor bolts as shown.
• Before installing the anchor bolts, make sure there
are no twists or kinks in the front seat belt.
• Make sure th e seat belt tensioner connecto r is
connected securely.
• Enter the anti-theft code for th e radio, then enter
the customer's radio station presets.
Icont'dl
24-3