Rear Window Wiper Arm And Motor Replacement; Washer Reservoir Replacement - Honda CR-V 1997 Service Manual

Rear Window Wiper Arm and
Motor Replacement
CAUTION: Put on gloves to protect your hands.
NOTE : Take care not to damage the rear hatch glass.
1. Remove the rear window wiper arm.
.: Nut IDeations, 3
~
6x1.0mm
I2t:I
9.8 N·m 11.0 kgf·m.
721bf.ltl
... : Screw locations, 2
REAR WIPER
LOWE\OVER
REARWlNOOW
WIPER MOTOR
/
2.
SPECIAL NUT
lax1.0mm
9 N·m 10.9 kgf·m.
~---..JW1L::jF~?--'""":7
5. I Ibf.ltl
(
'"
REAR WINDOW
WIPER ARM
CAP
..... ......
WASHER
NUT
6x1 .0mm
9.8 N·m 11.0 kgf·m.
7.2 IbUtl
Remove the rear wiper lower cover.
3. Disconnect the connector, then remove the rear
window wiper motor.
4. Installation is the reverse of the removal procedure.
NOTE :
• Make sure the connector is connected properly.
• Install the rear window w iper arm as described
on page 20· 103.
• Check the reaf window wiper motor operation.
• Grease the moving parts.
Washer Reservoir Replacement
CAUTION: Put on gloves to protect your hands.
1. Remove:
• Front grille Isee page 20·771
• Front bumper Isee page 20·72)
• Front wheel (left side, see section 18)
• Front wheelwell protector (left side, see page 20-
89)
• Inner fender lIeft side. see page 20·89)
• Headlight lIeft side. see section 23)
2. Disconnect the washer tubes and washer motor
connectors.
1Ii-:
Bolt locations, 3
~ 6x1.0mm
9.8 N·m 11.0 kgf·m,
7.2 IbHtl
Route the washer tubes
as
shown.
WASHER
RESERVOIR
WINDSHIELD
WASHER MOTOR
REARWINOOW
WASHER MOTOR
CONNECTORS
CLIP .
~:~
~ ~I ~ (~ ~ASHER
~
TUBES
3. Remove the bolts, then remove the washer reser-
voir.
4. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the washer motor connectors and
washer tubes are connected properly.
• Check the washer motor operation.
20-99