Honda CR-V 1997 Service Manual page 382

Fuel Supply System
Fuel Injectors (cont'd)
8. Slide new cushion rings onto the fuel injectors.
9. Coat new
O ~ rings
with clean engine oil, and put them on the fuel injectors.
10. Insert the fuel injectors into the fuel rail first.
11. Coat new seal rings with clean engine oil, and press them into the intake manifold ,
12. To prevent damage to the O-rings, install the fuel injectors in the fuel rail first, then install them in the intake mani-
fold.
FUEL RAil
13. Install and tighten the retainer nuts.
14. Connect the vacuum hoses and fuel return hose to the fuel pressure regulator.
15. Connect the PCV valve .
The illustration shows
'97 - 98 models, '99 - 00 models
are similar.
16. Connect the connectors to the fuel injectors, the IAT sensor ('97 - 98 models), and the EVAP purge control solenoid
valve ('97 - 98 modelsl.
17. Coat a new O-ring with clean engine oil, and install the resonator chamber ('99 - 00 models).
18. Turn the ignition switch ON HI), but do not operate the starter. After the fuel pump runs for approximately two seconds,
the fuef pressure in the fuel line rises . Repeat this two or three times, then check whether there is any fuel leakage.
11-180