Pressure Testing; Changing - Honda CR-V 1997 Service Manual

Changing
NOTE: Keep all foreign particles out of the transmis-
sion.
1. Bring the transm ission up to operating temperature
(the radiator fan comes on) by driving the vehicle.
Park the vehicle on level ground. turn the engine
off, then remove the drain plug.
NOTE: If
a
cooler flusher is to be used, see page
14-264 and 14-265.
2, Reinstall the drain plug with a new sealing washer,
then refill the transmission with the recommended
fluid to the upper mark on the dipstick. Always use
Genuine Ho nd a Premium Formula Automatic
Transmi ssion Fluid (ATF). Using a non-Honda ATF
can affect shift quality.
Automatic Transmission Fluid Capacity:
4WD:
2.9
f
(3.1 US qt, 2.6 Imp qt) at change
6.8
f
(7 .2 US
qt,
6.0 Imp qt) at overhaul
2WD:
2.7 f (2.9 US qt, 2.4 Imp qt) at change
5.9 f (6.2 US qt, 5.2 Imp qt) at overhaul
Pressure Testing
testing, be careful of the rotating wheels.
• Make sure lifts, jacks, and safety stands are placed
properly (see section 11.
1, Before testing. be sure the transmission fluid is
filled to the proper level.
2. 4WD:
Raise the vehicle (see section
1).
2WD:
Ra ise the front of the vehicle, and make sure it is
securely supported. Set the parking brake, and block
both rear wheels securely.
3. Allow all four wheels (4WD) or front wheels 12WD)
to rotate freely.
4. Warm up the engine (the radiator fan comes on),
then stop it and connect the tachometer.
5.
Connect the oil pressure gauges to each inspection
hole securely, and do not allow dust or other foreign
particles to enter the inspection holes.
TOROUE: 18 Nom (1.8 kg/·m, 13Ibf·ft)
AIT OIL PRESSURE
GAUGE SET WfPANEL
07406 - 0020400
@J
-,
AfT LOW PRESSURE
GAUGE WfPANEL
07406 - 0070300
Q
AfT PRESSURE HOSE,
2210 mm
07MAJ - PV<Ot1A
14 Required)
AfT PRESSURE HOSE
ADAPTER
07MAJ - PV<0120
(4 Required)
6. Measure the following pressure:
• line Pressure .................................. .. ........
14-162
• 1st, 1st-hold Clutch Pressure .............. ..... 14-162
• 2nd, 3rd and 4th Clutch Pressure ............ 14-163
7. Install new sealing washers and the sealing bolts in
the inspection holes, and t ighten to the specified
torque.
TOROUE: 18 N'm 11 .8 kgf·m, 131bf.ftl (cont' d)
14-161