Reassembly - Honda CR-V 1997 Service Manual

Power Steering Pump
Reassembly
1. Align the pin of the sub-valve with the oil passage
in pump housing, and push down the sub-valve.
Install the snap ring properly.
PUMP HOUSING
OIL PASSAGE
Align the pin of
sub-valve with
o
SUB-VALVE
SNAP RING
2. Install the new pump seal (with its grooved side fac-
ing in) into the pump housing
by
hand, then install
the pump seal spacer.
3. Position the pump drive shaft in the pump housing,
then drive
it
in using a 29 mm socket as shown.
40 mm CIRCLIP
29
mm
SOCKET
o
PUMP DRIVE SHAFT
4. Install the 40 mm circlip with its radiused side fac-
ing out.
17-28
5. Coat the pump cover seal with power steering fluid,
and install it into the groove in the pump cover.
ROllER SET HOLES
Ii
PUMP COVER SEAL
Replace .
4.5 mm ROLLER
5mm ROLLER
PUMP COVER
6. Install the outer side plate over the two rollers.
MARK
ROLLERS
7. Set the pump cam ring over the two rollers with the
.. . " mark on the cam ring upward.