Under-Dash Fuse/Relay Box - Honda CR-V 1997 Service Manual

Under-dash Fuse/Relay Box
Removal/Installation
SRS components are located in this area. Review the
SAS co mponent locat ions, precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice.
Removal:
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the rad io's pre-
set buttons (with anti-theft feature).
2. Disconnect the battery negative cable, th en discon-
nect the positive cable, and wait at least three min-
utes.
3. Remove the driver's dashboard lower cove r and the
knee bolster (see section 20).
4. Remove the two mounting nuts, and pull the under-
dash fuse/r elay box out from under the dash.
UNDER·DASH
FUSE/R£LAY BOX
MOUNTING NUTS
5. Disconnect the connectors from the under-dash
fuse/relay box (see section 24 f or the SRS main har-
ness connector), and take out the under-dash fusel
relay box.
Installation:
r:-:1
~
1. Conn ect the connectors to the under-dash fusel
relay box (see section 24 for the SRS main harness
connector), then install the under-dash fuse/ relay
box in the reverse order ofremoval.
2. Install the knee bolster and the driver's dashboard
lower cover (see section 20).
3. Connect the battery positiv e cable, then connect the
negative cable.
4.
Enter the anti-theft code for the radio, then enter the
customer's radio station presets (w ith anti -theft fea-
ture) .
5. Confirm that all systems work properly.
23-49