Intermediate Shaft Removal - Honda Civic 2002-2003 Service Manual

•
•
8. Install a new spindle nut (A), then tighten the nut.
After tightening, use a drift to stake the spindle nut
shoulder (8) against the driveshaft.
A
22x 1.5 mm
181 N·m
118.5 kgl·m, 1341bl·ltl
108 N·m
111.0 kgl·m.
lOlb,.ltl
o
00
. .
9. Clean the mating surfaces of the brake disc and the
front wheel, then install the front wheel with the
wheel nuts .
10. Turn the front wheel by hand, and make sure the
clearance between the driveshaft and
circumference parts.
11. Refill the transmission with recommended
transmission fluid (see page 13-3).
12. Check the front wheel alignment, and adjust it if
necessary (see page 18-4).
Intermediate Shaft Removal
1. Remove the right driveshaft (see page 16-3).
2. Remove the heat shield.
3. Remove the flange bolt (A) and two dowel bolts (8).
A , B
'1(
~
--------,
-4'\ .
.~
Icont'd)
16-19