Pressure Plate - Honda CR-V 1997 Service Manual

Pressure Plate
Removal/Inspection
1. Check the diaphragm spring fingers for height using
the special tools and a feeler gauge.
Standard INew): 0.6 mm 10.02 in) max.
Service Limit: 0.8 mm 10.03 in)
HANDLE
07936 - 3710100
/ , \ _ CLUTCH ALIGNMENT DISC
~
07JAF-PM7011A
.~-----)
CLUTCH ALIGNMENT SHAFT
-=-~
07NAF - PR30100
' ., ..... " GAUGE
If the height is more than the service limit, replace
the pressure plate.
2. Install the special tools as shown.
PRESSURE
CLUTCH ALIGNMENT SHAFT
07NAF - PR30100
HANDLE
07936 - 3710100
RING GEAR HOLDER
07LAB - PVOO100 or
07924 - PD20003
RING GEAR HOLDER ADJUSTER NUT
ENGINE
"UX;~
_ _ _ _
BOLT
WASHER
3. To prevent warping, unscrew the pressure plate
mounting bolts in a crisscross pattern in several
steps, then remove the pressure plate.
4. Inspect the pressure plate surface for wear, cracks.
and burning.
5. Inspect the fingers of the diaphragm spring for wear
at the release bearing contact area.
DIAPHRAGM SPRING
PRESSURE PLATE
6. Inspect for warpage using a straight edge and feeler
gauge. Measure across the pressure plate.
Standard INew): 0.03 mm 10.001 in) max.
Service Limit: 0.15 mm 10.006 in)
PRESSURE PLATE
FEELER GAUGE
STRAIGHT EDGE
If the warpage is more than the se rvi ce limit,
replace the pressure plate.
12-7