Honda CR-V 1997 Service Manual page 824

Inboard Joint Side:
1. Wrap the splines with vinyl tape to prevent damage
to the boot and dynamic damper.
2. Install the inboard boot to the driveshaft, then
remove the vinyl tape. Take care not to damage the
boot.
3. Install the spider onto the driveshaft by aligning the
mark on the spider and the end of the driveshaft.
o-CIRCLIP
Mork
~
SPIDER
4. Fit the circlip into the driveshaft groove. Always
rotate the circlip in its groove to make sure it is fully
seated.
5. Fit the rollers to the spider.
NOTE:
• Reinstall the rollers to their original positions on
the spider by aligning the marks .
• Hold the driveshaft pointed up to prevent the
rollers from falling off.
High shoulder faces
toward outside
6. Pack the inboard joint with the joint grease included
in the new driveshaft set.
Grease quantity: 120 - 130 9 (4.2 - 4.6 oz)
Left inboard joint splines
@:
0.5 - 1.0 g (0.018 - 0.035
oz)
(cont'd)
16-9