Table of Contents
Advertisement
Power Mirrors
Function Test
1.
Pry the switch
out
of the dashboard. Be
careful
not
to
damage the
mirror
switch
or the
dashboard
driv·
er's
lower
cover
when
prying
the
switch
out.
2.
Disconnect the 10P connector from the switch.
3.
Choose the appropriate test dased on the
symptom:
•
Both mirrors
don't
work,
go to
step
4.
•
Left mirror doesn't work. go
to
step 6.
•
Right mirror doesn't work, go to step 7.
lOP CONNECTOR
-~
/
VEL/RED
Wire side
of
BlK~EL
\
Br
~:
l3;
1
:1
]
BLU/~HT
/
VEL/BLK \
female
termInals
[Q
\
POWER
MIRROR
SWITCH
BLU/BlK
GRN/WHT
~
Both inoperative:
4.
Check for voltage between the No.2 (BLK/YEL)
ter-
minal and body ground with the ignition switch ON
(II).
There should be battery voltage.
•
If there
is
no
voltage, check
for:
-
blown
No.
17 (7.5
A)
fuse in the under-dash
fuse/relay box.
-
an
open in the BLKJYEL wire.
•
If there is battery voltage, go to
step
2.
5.
Check for continuity between the No.4 (BLK)
termi-
nal and body ground.
There should be continuity.
If there
is
no
continuity, check
for:
•
an open in the
BlK
wire.
•
poor ground (G551).
23-108
Left
mirror inoperative:
6.
Connect the No.2
(BLK/YEL)
terminal of
the lOP
connector to the No.3 (YELJRED) terminal and the
No.5 (or No.6) terminal to body ground with
jumper wires
.
The left
mirror
should tilt down
(or
swing left) when the
ignition
switch is turned ON
(II).
•
If the mirror does not tilt down (or does not swing
left), remove the left door panel, and check for an
open
in
the BLUNVHT (or BLU/BLK) wire between
the left power mirror and the switch. If the wire is
OK.
check
the left power mirror actuator.
•
If the mirror neither tilts down nor swings
left,
repair the YELJRED wire.
•
If the mirror operates properly,
check
the mirror
switch.
Right
mirror
inoperative:
7.
Connect the
No.
2
(BLK/YEL)
terminal
of the lOP
con-
nector to the No.3 (YElJRED) terminal and the No.9
(or No.8) terminal to body ground with jumper wires.
The right
mirror should
tih
down (or swing left) when
the ignition switch is tumed ON
(II).
•
If
the mirror does not tilt down (or does not
swing
left),
remove the right door panel, and
check
for an
open
in the GRNNVHT (or YELJBLK)
wire between the right power mirror
and
the
switch.
If the wire is OK,
check
the right power
mirror actuator.
•
If the mirror neither tilts down nor
swings left.
repair the YELJRED wire.
• If the mirror operates properly.
check
the mirror
switch.
Advertisement
Table of Contents
Troubleshooting
