Honda CR-V 1997 Service Manual page 1341

From page 24 · 42
(AI
I
Check the SRS unit:
Connect the
SAS main
harness
l8P
connector terminals No.
3 and No. 6 with a jumper wi re and backprobe adapters.
Does the SRS indicator light go off?
YES NO
Fauttv SRS unit or poor contact at the SRS main harness
l8P
connector; check the connector.
If the connector is OK, replace the SRS unit.
I.
Did fuse No.
23 (10 AI blow?
I
YES NO
(BI
To page 24-44
Check for a short to ground in the SRS indicator light cir-
cuit:
1,
Turn the ignition switch OFF .
2,
Disconnect the dashboard wi r e ha r ness 5P co nnector
from the gauge assembly.
3, Check resistance between the No.1 termin al of th e dash-
board wire harnes s 5P connector and ground . There
should be 1 MO or more.
I.
the resistance as specified?
YES NO
(el
To page 24-45
Short to ground in the gauge auembly; replace the gauge
assembly.
SRS UNIT
SRS MAIN HARNESS
1ap CONNECTOR
SRS MAIN HARNESS 1 ap CONNECTOR
JUMPER WIRE
3 4 5 6 7 8 9 C806
10 11 12 13 14 15 16 17 18
Wire
side
of female
terminals
DASHBOARD WIRE HARNESS
5P CONNECTOR
DASHBOARD WIRE HARNESS
5P CONNECTOR
3
~
C509
,+,,'--'-'-,,"-LJ
BLU
Wire side of female
termi nals
(cont'd)
24-43