Honda CR-V 1997 Service Manual page 641

Troubleshooting Flowchart
- I
D4 i
or
[Q]
Indicator Light On Constantly
The
~
or
~
indicator light is on
constantly (not blinking) when-
ever the ignition switch is ON
III).
Measure 0. INO or 0 INO Vottage:
,. Turn the ignition switch OFF.
2. Disconnect the A (32P ) con-
nector from the PCM .
3. Turn the ignition switch ON
(II).
4. Measure the voltage between
the A' 4 terminal and body
ground .
Is there voltage?
NO
Measure ATP 0' Vottage:
1. Turn the ignition switch OFF.
2. Connect the A 132P) connec-
tor to the PCM .
3. Turn the ignition switch ON
(It).
4. Shift to any position ather
than
[Q!]
or
[Q].
5. Measure the vohage between
the 09 terminal and body
ground .
Is there approx. 5 V?
NO
Test the
AJT
gear position switch
(see page 14-139),
Is the switch OK?
YES
Check for. short to ground in the
wire between the D9 terminal and
AfT
gear positjon
switch.
tf
wire
is
OK, substitute a known-good PCM
and recheck.
YES
YES
NO
PCM CONNECTORS
A 132P) B I25P) C
131P)
Wire side of fema le terminals
R8JHIir short to power in the wire
between the A14 terminal and
the gauge assembly.
A (32P)
B (25P)
Test the AlT gear position indi-
cator at the gauge assembly can·
nectars (see page 14·139 for '98
model and U·140 for '99 - 00
models). If the AfT gear position
indicator is OK. replace the PCM,
Replace the All gear position
,witch,
C 131P)
DII6P)
DII6P)
14-125