Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 43

B-2
BODY DIMENSIONS -
Projecteddimension
Height
Probe
Actually-measured
dimension
A
Bolt
Measuring point
Body Dimensions and Measurement Methods
BODY DIMENSIONS AND
MEASUREMENT METHODS
1. Type A (projected dimensions)
2. Type B (actual-measurement dimensions)
A'
3. Insert the tracking gauge probes securely into the
Centre
of hole 4. When the standard dimensions in the illustration are
5. When using a notch for dimension measurement, set
6. When measuring the suspension mounting arm, or link
7. The body centre points are shown for the purpose of
Indicates the dimension when a measurement location
is projected onto a plane.
The difference in height of the measurement points should
be taken into consideration when measuring.
Indicates the actual distance between the measurement
points.
Measure using a tracking gauge or a measuring tape,
etc.
NOTE
Make the lengths of the tracking gauge probes the
D
same (A=A').
Do not bend or twist the measuring tape.
D
measurement holes
enclosed by, this indicates that the symmetrical left and
right positions have the same dimensions.
the measuring point at the centre of the notch.
mounting position, use the suspension mounting bolt,
etc..
checking the position of the left and right symmetry
locations.