Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 37

C-20
Right
side
only
NOTE
For details on the weld points with the rear end panel refer to REAR END PANEL on P.C-18.
Rear seat back
reinforcement
200 ± 50 mm
WELDED PANEL REPLACEMENT -
C
E
NOTE ON REPAIR WORK
REMOVAL
1. Cut the rear floor panel 320 ± 10 mm from the back
Rear Floor
of the rear seat back reinforcement.
Cut the rear floor pan 200 ± 50 mm from the back of
the rear seat back reinforcement as shown in the
illustration.
(Vehicles
with ACD)
D
F