Mitsubishi Electric MELSEC iQ-R Series User Manual page 199

Error Error definition and causes
code
D912H Transient transmission sending failed.
D913H An error was detected in the network
to module.
D917H
D919H No response from the target station of the
communication test.
DA00H An error was detected in the network
module.
DA10H An error was detected in the network
to module.
DA17H
DA19H An error was detected in the network
module.
DA1BH A dedicated instruction which the target
station does not support was executed.
DA1CH The target station of the READ/SREAD/
WRITE/SWRITE/SEND/REQ instruction
does not exist.
DB00H Station No.121 or later is specified.
Action
• Execute the instruction again after lower the transient transmission usage
frequency.
• Check if the switching hub and the Ethernet cables are connected
properly.
Please consult your local Mitsubishi representative.
• Correct the network No., station No., or IP address for the target station of
the communication test.
• Check if the network configuration setting is correctly set in the master
station within the same network as the target station of the communication
test.
• When "IP Address" is selected for "Communication Method",
"Communication Test" cannot be executed for stations on networks
different from that of the connected station (own station). Change
"Communication Method" to "Network No./Station No.".
Please consult your local Mitsubishi representative.
Please consult your local Mitsubishi representative.
Please consult your local Mitsubishi representative.
• Change the target station at the station that executed the READ/SREAD/
WRITE/SWRITE/SEND/REQ instruction.
• Correct the network number and station number/IP address of the target
station of the dedicated instruction.
If the target station of the READ/SREAD/WRITE/SWRITE/SEND/REQ
instruction is disconnected, execute the dedicated instruction again after
return of the target station.
Check station No..
Detailed
information 1
Detailed
information 2









4 TROUBLESHOOTING
197
4.5 List of Error Codes
4