Mitsubishi Electric MELSEC iQ-R Series User Manual page 50

Devices where the hold/clear setting is enabled
The following table and figure show devices for which the hold/clear settings are enabled.
Setting items
Output mode upon CPU error
Output hold/clear setting during
CPU STOP
Data link faulty station setting
Precautions
■ When "Output Hold/Clear Setting during CPU STOP" is set to "Clear"
When the CPU module is in the STOP state, the forced output to device stations cannot be executed using the engineering
tool.
■ When making direct access to link devices
The output of "Output Hold/Clear Setting during CPU STOP" is enabled.
■ When the Safety CPU is used
When the safety operation mode is set to the safety mode, the data is cleared even when "Output Hold/Clear Setting during
CPU STOP" is set to "Hold".
1 FUNCTIONS
48
1.1 Cyclic Transmission
Hold/clear settings are enabled
• Master station RY
• Local station RY (only the output
data from the own station)
• Master station RY (if the link refresh
source device is other than Y)
• Local station RY (only the output
data from the own station, and if the
link refresh source device is other
than Y)
• Master station RX
• Local station RX
• Local station RY (only the input data
from other stations)
Hold regardless of setting

• Master station RWw
• Local station RWw (only the output
data from the own station)
• LB (only the output data from the
own station)
• LW (only the output data from the
own station)
• Master station RWr
• Local station RWr
• Local station RWw (only the input
data from other stations)
• LB (only the input data from other
stations)
• LW (only the input data from other
stations)
Clear regardless of setting

• Master station RY (if the link refresh
source device is Y)
• Local station RY (only the output
data from the own station, and if the
link refresh source device is Y)
