Device Station Setting; Safety Communication Setting - Mitsubishi Electric MELSEC iQ-R Series User Manual

Device Station Setting

Set items related to the device station.
Item
Disconnection Detection Setting

Safety Communication Setting

Set whether to use the safety communication or not and set safety connections.
Item
To Use or Not to Use the Safety
Communication Setting
Safety Communication Setting
Set the following items before configuring the safety communication setting.
• "Network Configuration Settings" in "Basic Settings" (Page 112 "CC-Link IE TSN Configuration"
Window)
If the above items are not set, the device station is not displayed as the target module in the "Select the target
module for the Safety Communication Setting" window and safety communications cannot be set.
Setting method
The procedure for the safety communication setting is shown below.
1.
Set "Communication Destination" to "Local Network".
2.
For the master station, select the target module of safety communications in the "Select the target module for the Safety
Communication Setting" window and click the [Add] button.
2 PARAMETER SETTINGS
104
2.3 Basic Settings
Description
Set the number of consecutive communication failures until a device station is
considered disconnected.
Description
Set whether to use the safety communication or not.
Set the safety connections and transfer ranges of safety devices required for
safety communications.
Setting range
• 2 times
• 4 times
• 8 times
(Default: 4 times)
Setting range
• Not to Use
• Use
(Default: Not to Use)
Page 104 Setting method