Mitsubishi Electric MELSEC iQ-R Series User Manual page 117

Simple Detailed Description
display display
CC-Link IE TSN Class For each device station, select which CC-Link IE TSN Class the device is.
*15
Setting
*1 If the setting cannot be confirmed in the module parameters and "Network Configuration Settings", a hyphen may be displayed or the
displayed calculation result may not be correct.
*2 When the communication cycle is set to 31.25 s or 62.50 s, the following restrictions are applied.
Ignore the value displayed in "Communication Period Interval (Minimum value)" of "Network Configuration Settings" when setting it.
In 'Communication cycle intervals (Calculation value)' (SW0072) and 'Cyclic transmission time (Calculation value)' (SW0073), 0 is
stored.
*3 When the version of Add-on baseSystem is "1.15" or earlier, set consecutive numbers less than or equal to the total number of stations.
*4 An error will occur when a value outside the setting range is set.
*5 When the version of Add-on baseSystem is "1.18" or earlier, an error occurs if "Not checked" is set.
*6 For the version of Add-on baseSystem, "1.4" or earlier, the station No. of the stations is "1 to 64".
*7 When the Add-on baseSystem version is "1.22" or earlier, an error will occur when the number of points are set.
*8 For the motion control station, only "No Setting" can be set. Any other setting will result in an error.
*9 When the version of Add-on baseSystem is "1.18" or earlier, only "No Setting" can be set for the motion control station. Any other setting
will result in an error.
*10 For the version of Add-on baseSystem, "1.4" or earlier, an error will occur when "Synchronous" is set.
*11 When the version of Add-on baseSystem is "1.22" or earlier, a "Network parameter error (error code: 2221H)" occurs if any setting other
than "Basic Period" is configured for any device station supporting CANopen communication.
*12 For the motion control station, only "Basic Period" can be set. Any other setting will result in an error.
*13 When the "CC-Link IE TSN Class" of the general CC-Link IE TSN module added to the list of stations under network configuration
setting is CC-Link IE TSN Class A, when the minimum value for the communication cycle interval and cyclic transmission time are set to
"Communication Period Interval Setting" and "Cyclic Transmission Time", cyclic transmission may not be possible. In this case, select
the actual devices to be used from "Module List" and add it to the list of stations, or check the maximum response time during time-
managed polling using the manuals of the devices used, and calculate and set the communication cycle interval and cyclic transmission
time.
*14 When the Add-on baseSystem version is "1.22" or earlier, an error occurs if "Local station" is set. If the add-on baseSystem version is
"1.24" or later, "Local station setting combination error (error code: 322BH)" occurs if the local station is set to "Motion control station".
*15 With the "CC-Link IE TSN Class" being a "CC-Link IE TSN Class A" station, if the number of points assigned to the link device exceed
the number of points that can be assigned, an error will occur.
Setting range
• CC-Link IE TSN Class B
• CC-Link IE TSN Class A
(Default: Automatically determined by the
profile)
2 PARAMETER SETTINGS
2.5 "CC-Link IE TSN Configuration" Window
2
115