Suzuki Grand Vitara 2011 Manual page 163

DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 10 sec.
4) Check DTC and pending DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting: For Petrol Engine Model".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 IAT sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch.
3) Check intake air temp. displayed on scan tool.
° °
Is 119 C (246 F) indicated?
3 ECM voltage check
1) Disconnect connector from MAF and IAT sensor with
ignition switch turned OFF.
2) Check for proper connection to MAF and IAT sensor at
"LT GRN" and "GRY/GRN" wire terminals.
3) If OK, then turn ON ignition switch, measure voltage
between "LT GRN" wire terminal of MAF and IAT sensor
connector (1) and vehicle body ground.
Is voltage about 4 – 6 V?
4 IAT short circuit check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Measure resistance between "LT GRN" wire terminal of
MAF and IAT sensor connector and vehicle body
ground.
Is resistance infinity?
Engine General Information and Diagnosis: For Petrol Engine Model 1A-94
Action
I5JB0A110037-02
Yes
Go to Step 2.
Go to Step 3.
Go to Step 6.
Go to Step 5.
No
Go to "Engine and
Emission Control
System Check: For
Petrol Engine Model".
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Go to Step 4.
"LT GRN" wire is
shorted to ground
circuit.
If wire is OK, substitute
a known-good ECM and
recheck.