Huawei TE30 User Manual page 58

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
Conference line
type
Conference
bandwidth
Dynamic
bandwidth
reserved
presentation
bandwidth
Preferred IP
protocol
Issue 01 (2013-03-27)
Description
Specifies the type of line used
during a conference.
If you select Auto and your TE30
has registered with a network
gatekeeper (GK), your TE30
preferentially uses H.323 to initiate
a conference.
Specifies the transmission
bandwidth for a conference.
If your TE30 accesses an E1
network through an IP line, set this
parameter to Limited for better
conference video quality.
Specifies whether the TE30
implements the following if the
packet loss rate increases due to
insufficient network bandwidth:
The TE30 automatically decreases
the conference bandwidth until
constant packet loss no longer
occurs or the conference bandwidth
is decreased to 64 kbit/s. If constant
packet loss is detected, the TE30
dynamically adjusts bandwidth to
recover stable conference quality
within 1 minute.
Disable this parameter if your site is
not going to send or receive
presentations during a conference
and the Received value for
Presentation bandwidth [frame
rate] is not -.
If this parameter is disabled, the
Received value for Presentation
bandwidth [frame rate] restores to
- when you rejoin the conference.
NOTE
To view the Presentation bandwidth
[frame rate] value, choose Advanced
> Diagnostics > Status >
Conference.
Specifies the protocol that IP sites
preferentially use.
When Line type is set to Auto for
IP sites, your TE30 uses this
protocol to call the IP sites.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Setting
The default value is Auto.
The default value is Normal.
This parameter is deselected by
default.
l When the network is running
properly, do not select this
parameter.
l When the network is not running
properly, select this parameter.
The default value is Enable.
The default value is H.323.
6 Conference
50