L-shaped bracket and hook- Accessorial integration cable HDMI cable and-loop fastener L-shaped bracket: secures the TE30 during This cable provides two female connectors and is Extends the HDMI cable for longer mounting. used to extend an HDMI cable for transmission over transmission.
Lens Uses 12x optical zoom lens. MODE button Restores the TE30 to its default settings if you press and hold this button for 10 seconds or more when the TE30 is operating properly. Huawei Proprietary and Confidential Issue 09 (2014-01-21)
Page 3
Connects to a VGA display device, such as a projector. Note: The TE30 itself weighs 2.1 kg, with the dimensions (H x W x D) of 157 mm x 235 mm x 167 mm (6.18 in. x 9.25 in. x 6.57 in.). ...
35 mm (1.38 in.). While drilling, make sure the two upper holes are in a straight line and parallel to the ground, so the TE30 is level after installation. Connect the cables delivered with the TE30. Then follow the steps in the following figure to install the TE30.
HUAWEI TE30 Videoconferencing Endpoint Free-Standing Place the TE30 on a flat surface. If you have to place the TE30 on an inclined surface, ensure that the inclination is less than 15° so that the TE30 can function properly. Inverted Installation Purchase a bracket for inverted installation and mount the TE30 onto the ceiling using the bracket.
Other Installation Options Purchase a tripod and install the TE30 on it. The tripod must be able to bear a weight of at least 10.5 kg (23.15 lb), and the sizes and positions of its holes must be the same as those of the holes on the bottom of the TE30.
Powering On the TE30 With all cables connected correctly, use the power adapter to connect the TE30 to a power supply. When the power adapter indicator turns on, the TE30 automatically powers on and the Wizard screen is displayed.
2. When prompted, click Yes. The TE30 automatically loads the configuration file and restarts. If you do not perform any operations within 10 seconds after you insert a USB device, the TE30 automatically loads the configuration file and restarts. 3. Remove the USB device.
Page 10
Static IP: Your network If you have set NMS server, select administrator assigns an IP Static IP for this parameter. address to your TE30. If you select this option, you must also set Local IP address, Subnet mask, and Gateway address.
If you have set NMS server, Local IP address, Subnet mask, and Gateway address, a dialog box is displayed. If you click Yes, the TE30 automatically attempts to obtain the NMS server settings. After the TE30 obtains the settings, it displays the conferencing screen. You do not need to set H.323 or SIP parameters.
Page 12
IP addresses. Site number Site number for the TE30. The site number can contain only digits. If the TE30 has registered with the GK, other endpoints can call the TE30 by Example: 12345 this number. H.323 ID Name by which the GK identifies the The name consists of digits, TE30 after it registers with the GK.
Whether to register with the SIP server. By default, this parameter is server deselected. If you select this parameter, the TE30 registers with the SIP server. After successfully registering with the SIP server, the TE30 can call endpoints defined in the address book by their IP addresses, numbers, and names.
Page 14
Site number Site number for the TE30. The site number can contain digits or a combination of If the TE30 has registered with the SIP digits and a domain name. server, other endpoints can call the TE30 by this number.