Huawei TE30 User Manual page 14

HUAWEI TE30 Videoconferencing Endpoint
User Guide
With all cables connected correctly, use the power adapter to connect the TE30 to a power supply.
The power adapter indicator with then turns on, and the TE30 is automatically powered on.
To power off your TE30, press
onscreen instructions.
Table 2-1
Table 2-1 Indicator status
Indicator
Status
Blinking
green
Steady green
Blinking red
Blinking
orange
Steady orange
Off
Your TE30 provides an organic light-emitting diode (OLED) display, which shows the IP
address, site number, and indications for startup, upgrade, sleep mode, and malfunction.
2-2
Table 2-2 OLED display content
When the TE30
Is...
Starting
Operating
correctly
Being upgraded
Sleeping
Malfunctioning
Issue 01 (2013-03-27)
lists TE30 indicator status.
TE30 Status
Starting
Operating correctly
Encountered a fault, such as a self-check error, overheating, or software
malfunction
Sleeping
Being powered off
Powered off
describes the content shown on the OLED display.
OLED Display Shows...
Message "Booting..."
switch between IP address and site number of the TE30 at 10-second
intervals
l Message "Downloading" during software downloads
l Message "Updating" during software updates
Message "Standby"
Indications that signify fan stop, overheating, or other faults, with a
hexadecimal error code after each indication
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Installation and Initial Configuration
on the remote control, select Shut Down, and follow the
Table
6