Requirements - Xilinx Virtex-7 FPGA VC7222 Getting Started Manual

5. Viewing GTZ Transceiver Operation, page 41
6. Closing the IBERT Demonstration, page 43

Requirements

The hardware and software required to run the GTH and GTZ IBERT demonstration are listed
here:
• Virtex-7 FPGA VC7222 GTH and GTZ Transceiver Characterization Board. The kit
includes:
One SD card containing the IBERT demonstration designs
°
One Samtec BullsEye™ cable
°
One skew-matched reference clock cable set
°
Eight SMA female-to-female (F-F) adapters
°
Six 50Ω SMA terminators
°
GTH transceiver power supply module (installed on board)
°
GTZ transceiver power supply module (installed on board)
°
SuperClock-2 module, Rev 1.0 (installed on board)
°
12V DC power adapter
°
USB cable, standard-A plug to Micro-B plug
°
• Host PC with:
SD card reader
°
USB ports
°
Vivado Design Suite 2015.1
°
The hardware and software required to rebuild the IBERT demonstration designs are:
• Vivado Design Suite 2015.1
• Host PC with a version of the Windows operating system supported by the Vivado
Design Suite
VC7222 IBERT Getting Started Guide
UG971 (Vivado Design Suite v2015.1) April 27, 2015
Chapter 1: VC7222 IBERT Getting Started Guide
www.xilinx.com 6
Send Feedback