Xilinx Virtex-7 FPGA VC7222 Getting Started Manual page 30

Attach the GTZ Quad Connector
Before connecting the BullsEye cable assembly to the board, firmly secure the blue
elastomer seal provided with the cable assembly to the bottom of the connector housing if
it is not already inserted (see
Attach the Samtec BullsEye connector to either GTZ Quad Q300A or Q300B
aligning the two indexing pins on the bottom of the connector with the guide holes on the
board. Hold the connector flush with the board and fasten it by tightening the two captive
screws.
Figure 1-22
CAUTION!
BullsEye cable is available, make sure to power down the board before moving the BullsEye cable to the
second half of the GTZ lanes
X-Ref Target - Figure 1-22
Figure 1-22: BullsEye Connector Attached to GTZ Quads Q300A and Q300B
VC7222 IBERT Getting Started Guide
UG971 (Vivado Design Suite v2015.1) April 27, 2015
Figure 1-4).
shows BullsEye cables connected to both Q300A and Q300B. If only one
www.xilinx.com
Chapter 1: VC7222 IBERT Getting Started Guide
(Figure 1-22),
30
Send Feedback