Xilinx Virtex-7 FPGA VC7222 Getting Started Manual page 33

Figure 1-24 shows the VC7222 board with both Q300A and Q300B Quads connected
(8 lanes) for the GTZ IBERT demonstration.
X-Ref Target - Figure 1-24
Figure 1-24: Cable Connections for the GTZ IBERT Demonstration
Configuring the FPGA
This section describes how to configure the FPGA using the SD card included with the
Virtex-7 FPGA VC7222 GTH and GTZ Transceiver Characterization Board. The FPGA can also
be configured through Vivado Design Suite using the .bit files available on the SD card,
or online (as collection rdf0297-vc7222-ibert-2015-1.zip) at the
VC7222 Characterization Kit documentation
VC7222 IBERT Getting Started Guide
UG971 (Vivado Design Suite v2015.1) April 27, 2015
Chapter 1: VC7222 IBERT Getting Started Guide
website.
www.xilinx.com
Virtex-7 FPGA
33
Send Feedback