Xilinx Virtex-7 FPGA VC7222 Getting Started Manual page 34

To configure the FPGA from the SD card:
1. Insert the SD card provided with the VC7222 board into the SD card reader slot located
on the bottom side (upper right corner) of the VC7222 board.
2. Plug the 12V output from the power adapter into connector J2 on the VC7222 board.
3. Connect the host computer to the VC7222 board using a standard-A plug to Micro-B
plug USB cable. The standard-A plug connects to a USB port on the host computer and
the Micro-B plug connects to U57, the Digilent USB JTAG configuration port on the
VC7222 board.
4. Select the GTZ IBERT demonstration with the System ACE SD Controller SYSACE-2 CFG
switch, SW8. The setting on this 4-bit DIP switch
configure the FPGA. A switch is in the ON position if set to the far right and in the OFF
position if set to the far left. For the Quad 300 GTZ IBERT demonstration, set ADR2 =
OFF, ADR1 = OFF, and ADR0 = ON. The MODE bit (switch position 4) is not used and can
be set either ON or OFF.
X-Ref Target - Figure 1-25
5. Place the main power switch SW1 to the ON position.
See Table 1-1 for more details on the System ACE configuration.
VC7222 IBERT Getting Started Guide
UG971 (Vivado Design Suite v2015.1) April 27, 2015
Figure 1-25: Configuration Address DIP Switch (SW8)
www.xilinx.com
Chapter 1: VC7222 IBERT Getting Started Guide
(Figure 1-25) selects the file used to
34
Send Feedback