Procedures - GE Dash 3000 Service Manual

Procedures

2000966-542D
Configuration: Procedures
Listed below are the patient monitor settings that can be configured.
Each procedure is described on the next pages.
From the Main Menu
"Set print locations"

From Service Mode
"Set Unit Name" on page 4-11

"Set Bed Number" on page 4-11

"Patient-Monitor Type"

"Admit Menu" on page 4-13

"Confirm or configure wireless LAN"

From Boot Code
"Set Defib Sync Voltage and pulse width"

"Set Line Frequency"

"Set CIC and QS protocol"

"Set MUSE system protocol"

"Transcutaneous Pace Blank Length"

"Set Country Selection"

"Set Language" on page 4-20

"Enable or disable AFIB Identification"

"Enable or disable IntelliRate"

"Analog Out Buzz" on page 4-22

Also see "Advanced user procedures"
"Set time and date"

"Transfer monitor defaults"

After completing all necessary procedures, go to
electrical safety checks"
Dash 3000/4000/5000
on page 4-10
on page 4-12
on page 4-14
on page 4-18
on page 4-18
on page 4-19
on page 4-19
on page 4-19
on page 4-20
on page 4-21
on page 4-21
on page 4-23 to
on page 4-23
on page 4-24
on page 8-1.
"Functional and
4-9