GE Dash 3000 Service Manual page 144

6-28
Troubleshooting: Wireless LAN
These values should be:
Association Status
Received Signal Strength Indicator
(RSSI)
Transmit Rate Status
If the association status is other than 01, it is likely 0B (SSID or PASS
KEY incorrect). Verify that the SSID and PASS KEY matches the access
point configuration. Go to
page 4-14 for steps to check the settings.
If signal strength and transmit rate statuses are less than the above
values, the source of the problem is likely the wireless network (access
point). Go to Analyze WIRELESS LAN STATUS screen below and
contact your local hospital IT department for further troubleshooting.
If association status, signal strength and transmit statuses meet the
requirements, then the wireless patient monitor is not the source of the
problem. Contact your local hospital IT department for further
troubleshooting.
Dash 3000/4000/5000
01
minimum user-defined value
05 or greater
"Confirm or configure wireless LAN" on
2000966-542D