Wiring Information - GE 90-30 PLC Series Installation And Hardware Manual

10

Wiring Information

You must purchase the mating female (socket type) 24-pin connectors (which mate with the I/O
Connector on the faceplate of the APM). This connector is available under catalog number
IC693ACC317. This connector has a solder eyelet receptacle and is part of an accessory kit.
Optionally, other types of the 24-pin connector (for different physical connections) are also
available.
Catalog numbers for these connectors and their associated parts are listed in the following table.
The list includes catalog numbers for three types of connectors: solder pin, crimp pin, and ribbon
cable. Each accessory kit contains enough components (D-connectors, backshells, contact pins,
etc.) to assemble ten single-ended cables of the type specified for each kit.
Table 10-5. Catalog Numbers for 24-Pin Connector Kits
IC693ACC316
(Solder Eyelet Type)
IC693ACC317
(Crimp Type)
IC693ACC318
(Ribbon or IDC Type)
Note: Wire for cables is 12 twisted pairs, #24 AWG (0.22mm
Additional tools from Fujitsu are required to properly assemble the crimped contact and ribbon
cable type connectors. The solder eyelet connectors (as provided in IC693ACC316) do not require
any special tooling.
Crimped Contact Connectors (as provided in IC693ACC317) require:
Ribbon Cable Connectors (as provided in IC693ACC318) require:
These tools need to be ordered from an authorized Fujitsu distributor. Three of the largest US
distributors for Fujitsu connectors are Marshall at (800)522-0084, Milgray at (800)MILGRAY, and
Vantage at (800)843-0707. If none of these distributors service your area, contact Fujitsu
Microelectronics in San Jose, California, USA via telephone at (408) 922-9000 or via fax at (408)
954-0616 for further information.
It is recommended that you order any necessary connector tooling with sufficient lead time to meet
your assembly requirements for these connectors. These tools are generally not stock items and
can have significant lead times from distribution. If you have any further questions about this
issue, please feel free to contact the GE PLC Hotline at 1-800-GE (1-800-433-
2682) or 804-978-6036.
10-46 Series 90-30 PLC Installation and Hardware Manual – August 2002
GE
Catalog Number Catalog Number
FCN-361J024-AU
FCN-360C024-B
FCN-363J024
FCN-363J-AU
FCN-360C024-B
FCN-367J024-AUF
FCN-367J024-AUH
Hand Crimping Tool
Contact Extraction Tool
Cable Cutter FCN-707T-T001/H
Hand Press FCN-707T-T101/H
Locator Plate FCN-367T-T012/H
Vendor
Solder eyelet receptacle
Backshell (for above)
Crimp wire receptacle
Crimp pin (for above, 24 needed)
Backshell (for above)
IDC (ribbon) receptacle, closed cover
IDC (ribbon) receptacle, open cover
2
).
FCN-363T-T005/H
FCN-360T-T001/H
Description
GFK-0356Q