Function Of Cable; Specifications - GE 90-30 PLC Series Installation And Hardware Manual

IC693CBL311/317/319/320
I/O Interface Cables for Power Mate APM Modules

Function of cable

The I/O Interface Cable assembly consists of a 24-pin I/O connector, a cable, and a 25-pin D-type
terminal block connector. This cable is used to connect the Power Mate APM Modules
(IC693APU301 and IC693APU302) to drives and machines. There are two male 24-pin
connectors mounted on the front of each Power Mate APM. Two of these I/O Interface cables are
required for connections to and from the drive and machine. Catalog number IC693CBL311 is 10
feet (3 meters) in length and IC693CBL319 is 3 feet (1 meter) in length. The cable wire code list
for these cables is provided in Table H-4.
An I/O cable assembly similar to IC693CBL311 and IC693CBL319, but with the drain shield wire
disconnected from pin B12 and brought outside of the cable housing through an 8" pigtail, is also
available in two lengths. Catalog number IC693CBL317 is 10 feet (3 meters) in length and
IC693CBL320 is 3 feet (1 meter) in length. This cable improves the Power Mate APM's noise
immunity. The cable wire code list for these cables is provided in Table 10-5.
To make wiring to the drive and machine easier, each connector on the module is typically
connected by a short cable (the I/O Interface cable) to a terminal block. The cable that connects
from the I/O connector to an external terminal block can be shortened to meet the requirements of
your installation. See manuals GFK-0840 (standard mode) or GFK-0781 (follower mode) for
details on APM terminal blocks.
Figure 10-30. I/O Connector Cable Specifications

Specifications

Cable Length
Connector
GFK-0356Q Chapter 10 Cables
B1 A1
B12 A12
I/O
CONNECTOR
* Cable for IC693CBL311/319 shown. Cables IC693CBL317/320 have 8" external wire
connected to drain shield.
10 feet (3 meters) and 3 feet (1 meter)
24-pin female, Fujitsu part number FCN-363J024 (crimp wire type.
1 or 3 METERS
TERMINAL BLOCK
CONNECTOR
10
Cables
10-45