Possible Uses For These Cables (Factory Or Custom Built) - GE 90-30 PLC Series Installation And Hardware Manual

Figure 10-39. Dimensions for Depth of Connector in front of PLC for Custom Built Cables

Possible Uses for These Cables (Factory or Custom Built)

GFK-0356Q Chapter 10 Cables
1.5-2.5"
Typical
Connecting from the 24-pin connectors on a 32-point module to either a user-supplied terminal
strip/block or directly to I/O field devices (switches, lights, etc.).
Connecting from the 24-pin connector on a 16-point module that has a TBQC I/O faceplate
adapter to either a user-supplied terminal strip/block or directly to I/O field devices (switches,
lights, etc.). Use the right side cable, IC693CBL328, for this purpose. See Appendix H for
information about TBQC (Terminal Block Quick Connect) options.
Connecting from the 24-pin connectors on a 32-point module through a conduit to a Terminal
Block Quick Connect terminal block. This can be accomplished by attaching one of the
optional 24-pin connectors to the stripped end after pulling the cable through the conduit. See
the section "Building Custom Length Cables" for information on the connector options. See
Appendix H for information about TBQC (Terminal Block Quick Connect) options.
Connecting from the connector on a 16-point module that has a TBQC I/O faceplate adapter
through a conduit to a TBQC terminal block. This can be accomplished by attaching one of
the optional 24-pin connectors to the stripped end after pulling the cable through the conduit.
Use the right side cable, IC693CBL328, for this purpose. See the section "Building Custom
Length Cables" for information on the connector options. See Appendix H for information
about TBQC (Terminal Block Quick Connect) options.
Cables
PLC (Side View)
2.187"
10
10-61