Connector Depth - GE 90-30 PLC Series Installation And Hardware Manual

Figure 10-34. Connector Orientation on I/O Faceplate
B1 A1
B12 A12
Figure 10-35. I/O Faceplate to Terminal Block Cable

Connector Depth

The following illustration shows the space required in front of the PLC when this cable is
connected to a module. The depth of the cabinet that the PLC is mounted in should allow for the
depth added by this connector.
GFK-0356Q Chapter 10 Cables
Top of I/O Faceplate
Pin A1
Pin A12
IC693CBL321 3 feet (1 meter)
IC693CBL322 6 feet (2 meters)
IC693CBL323 1.5 feet (0.5 meter)
* Length is measured from backs of connector shells as shown above
Pin B1
Pin B12
Length*
10
Cables
A1 B1
A12 B12
10-55