Cpu352; Catalog Number Ic693Cpu352 - GE 90-30 PLC Series Installation And Hardware Manual

5

CPU352

CPU Type
Total Baseplates per System
Load Required from Power Supply
Processor Speed
Processor Type
Operating Temperature
Typical Scan Rate
User Program Memory (maximum)
Discrete Input Points - %I
Discrete Output Points - %Q
Discrete Global Memory - %G
Internal Coils - %M
Output (Temporary) Coils - %T
System Status References - %S
Register Memory - %R
Analog Inputs - %AI
Analog Outputs - %AQ
System Registers
(for reference table
viewing only; cannot be referenced in logic
program)
Timers/Counters
Shift Registers
Built-in Serial Ports
Communications
Override
Battery Backed Clock
Interrupt Support
Type of Memory Storage
PCM/CCM Compatibility
Floating Point Math Support
The CPU352 is supported by Logicmaster 90-30/20/Micro programming and configuration software Release 7.00 and
later releases, and Control programming and configuration software Release 2.0 and later releases.
5-36 Series 90-30 PLC Installation and Hardware Manual – August 2002

Catalog Number IC693CPU352

Single slot CPU module
8 (CPU baseplate + 7 expansion and/or remote)
890 milliamps from +5 VDC supply
25 MegaHertz
80386EX
0 to 60 degrees C (32 to 140 degrees F) ambient
0.22 milliseconds per 1K of logic (boolean contacts)
Starting with firmware Release 9.0, 240K Bytes. Note: Actual
size of available user program memory depends on the
amounts configured for the %R, %AI, and %AQ configurable
word memory types (see below).
For firmware prior to Release 9.0, fixed size is 80K bytes.
2,048
2,048
1,280 bits
4,096 bits
256 bits
128 bits (%S, %SA, %SB, %SC - 32 bits each)
Starting with firmware Release 9.0, configurable in 128 word
increments from 128 to 16,384 word with Logicmaster and
from 128 to 32,640 words with Control version 2.2. For
firmware prior to Release 9.0, fixed size is 9,999 words.
Starting with firmware Release 9.0, configurable in 128 word
increments from 128 to 16,384 word with Logicmaster and
from 128 to 32,640 words with Control version 2.2. For
firmware prior to Release 9.0, fixed size is 9,999 words.
Starting with firmware Release 9.0, configurable in 128 word
increments from 128 to 16,384 word with Logicmaster and
from 128 to 32,640 words with Control version 2.2. For
firmware prior to Release 9.0, fixed size is 9,999 words.
28 words (%SR)
>2,000
Yes
Three ports. Supports SNP/SNPX slave (on power supply
connector) and RTU slave, SNP/SNPX master/slave , Serial
I/O (on Ports 1 and 2). Requires CMM module for CCM;
PCM module for RTU master support.
LAN - Supports multidrop. Also supports Ethernet, FIP,
Profibus, GBC, GCM, GCM+ option modules.
Yes
Yes
Supports the Periodic Subroutine feature.
RAM and Flash
Yes
Yes, hardware-based (built-in math co-processor)
CPU 352
SNP
P1
P2
ON/RUN
OFF/
STOP
PORT 1
RS-232
PORT 2
RS-485
Model 352 CPU
GFK-0356Q