GE 90-30 PLC Series Installation And Hardware Manual page 406

Cable Selection and Cross-Reference
Three cables are available for connecting between the module's faceplate connector and the
terminal block. The only difference in these cables is their length. These cables have right-angle
connectors on the module end to minimize the space required in front of the modules. These three
cables replace three obsolete cables that had straight connectors. Use the following table to select
the correct cable.
IC693CBL330
IC693CBL332
IC693CBL334
I/O Face Plate for 16-Point Modules
The I/O Face Plate (catalog number IC693ACC334) has a 24-pin connector, which provides the
connection to the applicable terminal block through a 0.5, 1, or 2 meter cable. This face plate
replaces the standard terminal board on the listed modules.
I/O Face Plate Installation
Step 1: Install terminal block assembly on DIN rail
Place the terminal block over the desired location on the DIN rail and snap into place.
Step 2: Remove 20-pin terminal assembly from module
GFK-0356Q Appendix H Terminal Block Quick Connect Components
Cable Catalog
Number
CBL Assembly, 24-pin, 90 Deg, Right Side, 1.0 Meter
length
CBL Assembly, 24-pin, 90 Deg, Right Side, 2.0 Meter
length
CBL Assembly, 24-pin, 90 Deg, Right Side, 0.5 Meter
length
JACKING
LEVER
1.
Open the plastic terminal board
Push up on the jacking lever to release
the terminal block.
TBQC Components
Description
PULL
TAB
2.
Grasp pull-tab towards you until contacts
separated from module housing and hook
disengaged for full removal.
H
Replaces Obsolete
Cable Number
IC693CBL321
IC693CBL322
IC693CBL323
H-3