Ic693Cbl327/328 I/O Interface Cables With Right Angle 24-Pin Connector; Description; Applications - GE 90-30 PLC Series Installation And Hardware Manual

IC693CBL327/328
I/O Interface Cables with Right Angle 24-Pin Connector

Description

These cables each have a right-angle 24-pin connector on one end and a set of stripped wire ends
on the other. These two cables are identical except for their opposite connector orientations. This
difference in the cables' connector orientations is for the purpose of matching the opposing
connector orientations on the dual-connector type of 32-point I/O modules.
Figure 10-37. C693CBL327/328 Cables

Applications

These cables are for use with Series 90-30 I/O modules that have the Fujitsu 24-pin user I/O
connector. There are two categories of these modules:
GFK-0356Q Chapter 10 Cables
These cables replace obsolete I/O Interface cable IC693CBL315. These
Note:
replacement cables have right-angle connectors to reduce the clearance
space required in front of the PLC. These replacement cables use the
same pin-outs as the obsolete cables.
10 Feet (3 Meters)
Each conductor in these 24-conductor cables has a current rating of 1.2 Amps. If
using these cables with a 16-point Output module with a higher output current
rating, you must use the lower value of 1.2 for the maximum load current rating .
If you have field devices that require more than 1.2 Amps, do not use a TBQC
assembly. Use the standard Terminal Board instead.
32 point modules with two 24-pin connectors (IC693MDL654, IC693MDL655,
IC693MDL752, and IC693MDL753). The IC693CBL327 cable is for the modules' left side
connector (front view), and the IC693CBL328 cable is for the modules' right side connector.
The modules' right side connector interfaces with I/O circuit groups A and B; the modules' left
side connector interfaces with groups C and D. See Chapter 7, "Input and Output Modules"
Note
10
Cables
10-57